Flat price quote
Parts and labor, before work starts
Shower repair in Houston is the work of finding the failed cartridge, valve or seal and testing the valve, drain and pan connection before leaving. A shower that drips all day, leaks into the wall, or runs weak is usually a cartridge, a valve or a seal, not a new shower. El Primo Lalo Plumbing repairs showers in Houston, finds the failed part, and tests the valve, the drain and the pan connection before leaving.
Every shower repair starts with a real diagnosis and ends with a tested fix. Here's what's covered in a standard visit, and what we'll flag separately if we find it.


We repair showers in houses, condos, and townhomes across Houston. Whether it's a dripping valve, a slow drain, or a leak behind the tile, we find the source and fix it.
We repair showers in gyms, salons, apartment complexes, and other commercial properties. We work around your operating hours so tenants and customers aren't left with a cold or dripping shower.
Shower diagnosis splits three ways: the valve, the drain and the pan. A dripping shower head is usually a cartridge. A leak into the wall is usually the valve body or a supply connection. Water on the floor outside the shower points to the drain, the pan or a failed seal. Each has its own fix, and a leak into a wall is the one to act on fast, because it soaks framing and subfloor quietly.
Houston's hard water, about 8 grains per gallon on average, scales cartridges and shower heads, so low pressure and drips are constant calls here. In older homes, the valve is often set in tile that cannot be matched, so we repair through the trim where possible and explain honestly when the wall has to open.
A shower leak hides in the wall. Find the valve, the drain or the pan, and fix that one.
No mystery, no surprise charges. Here's exactly what happens from the moment you call to the moment you step back into a working shower.

Pinpoints a hidden shower leak behind tile or in the wall without tearing out more than necessary.

Checks the shower drain and the line it ties into, so we can see a blockage or break instead of guessing.

Used to open valve bodies and cut supply lines cleanly when a section needs replacing.

Makes a fast, code-correct PEX or copper connection without soldering in tight shower walls.

Used for copper pipe repairs where a soldered joint is the right call.

Clears hair, soap scum, and scale from a slow shower drain before it backs up.

Standard trade-grade equipment for inspecting and testing plumbing lines.

Every repair follows the UPC as adopted in Texas, including proper valve installation, drain slope, and supply line sizing. That keeps the work code-correct and inspection-ready.
We use a leak detection microphone and moisture checks to find the source, then repair the valve, drain, or supply line causing it. We open only what's needed and test the repair under pressure before closing up. The leak stops, the stain stops growing, and you avoid replacing a whole ceiling. Most of these repairs finish in one visit.
We check the cartridge, showerhead screen, and supply lines for scale and corrosion. If the valve is scaled up, we replace the cartridge and flush the line. We also check the water heater if hot water is slow everywhere. Full pressure returns and hot water reaches the shower faster. You stop running the water for a minute just to get it warm.
We repair the valve with OEM parts, test it, and give you a clear rundown of what was fixed. If the buyer or tenant needs documentation, we note the repair and the parts used. The inspection item clears, the shower works, and the deal doesn't stall over a small repair.
We check the drain for a dry trap, inspect the pan and valve for slow leaks, and run the shower to confirm it drains. If the trap is dry, we refill it and check for sewer gas. If there's a leak, we repair it. The smell clears, the shower is usable again, and you know whether it was a dry trap or a real leak.
Shower valve and cartridge work is city-wide, with older tiled showers in the Heights, Montrose and River Oaks needing trim-side repairs, and slab homes in Sharpstown and Meyerland where a pan leak can hide against concrete.
A 1940s Heights home had a shower that dripped constantly, and the ceiling below had a growing stain. The valve was an original with a worn cartridge, and the seat was scaled from years of hard water.
We replaced the cartridge and seats with OEM parts, tested the valve hot and cold, and confirmed the drip stopped. The ceiling stain stopped growing, and the homeowner scheduled a drywall patch. The repair took about two hours.
We recommended a water softener to slow scale buildup and told the homeowner to run the shower briefly each week to keep the valve exercising.
A Meyerland home had water pooling in the shower pan and a musty smell in the adjacent closet. The drain gasket had failed, and water was seeping into the subfloor. The shower had not drained properly in weeks.
We replaced the drain gasket and strainer, cleared the drain with a plumber's auger, and pressure-tested the drain. The pan dried out, the smell cleared, and the shower drained in under a minute. The repair took one visit.
We told the homeowner to clean the strainer monthly and to watch for slow draining, which is the first sign of a clog.
A Galleria-area condo had weak shower pressure and a handle that was hard to turn. The cartridge was scaled and the showerhead screen was clogged. The homeowner had tried a new showerhead with no improvement.
We replaced the cartridge with an OEM part, cleared the showerhead screen, and checked the supply lines. The pressure came back to full and the handle turned smoothly. The repair took about 90 minutes.
We recommended soaking the showerhead in vinegar every few months to keep the screen clear and checking the cartridge annually.
Most shower problems start small and get expensive if you wait. Here are the ones we see most often in Houston homes, and how we handle them.

We replace the worn cartridge and seats with OEM parts, then run the valve hot and cold to confirm it shuts off clean. Most drip repairs finish in under two hours, and the water bill drops the next cycle. A steady drip wastes thousands of gallons a year and keeps the valve area wet, which corrodes the brass and softens the drywall behind the tile.

We check the drain assembly and pan, replace the gasket or strainer, and pressure-test the drain. If the pan is cracked, we repair or replace it so water goes where it should. We also check the ceiling below for damage. A failed drain gasket or cracked pan lets water into the subfloor, which leads to rot, mold, and a much bigger repair if it's ignored.

We flush the valve, clear the showerhead screen, and check the supply lines for corrosion. If the mixing valve is failing, we replace it with a matching OEM unit so the temperature holds steady. Low pressure is usually scale in the cartridge or a clogged showerhead screen, and a temperature swing often means a failing mixing valve. Both get worse over time.

We open the valve, remove the seized cartridge, and replace it with a new OEM part. If the stem or trim is damaged, we replace those too. The handle turns smooth again and the valve shuts off properly. A stiff handle usually means a seized cartridge or a broken stem, and forcing it can crack the valve body, turning a small repair into a wall-opening job.
A showerhead that drips once per second wastes more than 3,000 gallons a year, and a failed cartridge can leak far more behind the wall. We replace the worn cartridge and seats so the valve shuts off clean, which drops your water bill and keeps the tile dry.
Houston humidity means a slow shower leak never dries out. Moisture wicks into studs, drywall, and subfloor, and you end up replacing tile and framing instead of a new cartridge. Our shower leak repair Houston service finds the source before the damage spreads.
Low water pressure in the shower is usually scale in the cartridge or a clogged showerhead screen, not a city supply problem. We flush the valve, clear the screen, and check the supply lines so you get a full, even spray instead of a weak trickle.
Most shower repairs are a one-visit job. We stock common , , , and standard cartridges on the truck, so when you call for shower repair Houston during our hours — Monday through Sunday, 7:00 AM to 10:00 PM — we can often finish in one visit and have you showering normally when we leave.
Clear records you can keep and share.
Parts and labor, before work starts
Matched to your valve brand and model
Hot and cold run test before we leave
A shower leak is not always where the water shows up. The stain on the ceiling may come from the valve, the drain, or a supply line, and the repair depends on which one failed.
A cartridge is a replaceable part inside the valve. A valve body is the housing behind the wall. Cartridges are cheaper and faster to fix; a valve body swap is a bigger job.
Water pooling in the pan can come from a failed drain gasket or a cracked pan. The fix is different, so we check both before quoting the repair.
Houston's hard water wears cartridges and seats faster than soft water. Replacing the cartridge with an OEM part and adding a softener extends the life of the repair.

Outside these areas? Call and ask if we can reach you. (346) 776-8560
The cartridge inside the valve has worn or scaled up. Houston's hard water speeds that wear. A new cartridge stops the drip; the shower head itself is rarely the cause.
Usually the valve body or a supply connection behind the wall. Water in a wall soaks framing and subfloor, so this is the shower problem to act on fast. We open the smallest access that finds the leak.
A scaled shower head or cartridge is the usual cause in Houston, thanks to hard water. Low pressure at one fixture is a fixture problem; low pressure everywhere is a supply problem, and we check both.
Yes. Estimates are free, and you approve the written scope before work starts. We are open Monday to Sunday, 7:00 AM to 10:00 PM.
Call (346) 776-8560 for a free estimate. We find the failed valve, drain or seal, fix it, and test the shower before we leave, Monday to Sunday, 7:00 AM to 10:00 PM.
Call us at (346) 776-8560 to book shower repair or ask a question. We are open Monday to Sunday, 7:00 AM to 10:00 PM, and estimates are free.
The fastest way to book is a phone call. Tell us what is happening and we will give you a free estimate and a time that works, Monday to Sunday, 7:00 AM to 10:00 PM.
Open Mon–Sun, 7:00 AM–10:00 PM. Free estimates.