Written scope
What failed and what we will replace
Bathtub repair in Houston is the work of finding the failed trap, cartridge or seal and testing the drain and faucet before leaving. A tub that drains slowly, leaks at the faucet, or loses water through the overflow is usually a trap, a cartridge or a seal away from working again. El Primo Lalo Plumbing repairs bathtubs in Houston, finds the failed part, and tests the drain and the faucet before leaving.
Every tub repair includes a diagnosis, the repair itself, and a test before we leave. The list below covers what is standard on a typical job; if we find a failed supply line or a clogged main drain during the visit, we quote that work separately before starting it.


We repair tubs in houses, townhomes, and condos across Houston. Whether it is a crack in the surface or a leak at the drain, we confirm the source and fix the part that failed.
We work with property managers, landlords, and hospitality owners on tub and drain repairs. Scheduling is coordinated around tenants and guests, and every repair is documented for the file.
Bathtub diagnosis splits three ways: the drain, the faucet and the overflow. A slow tub is usually hair and soap scum in the trap and drain shoe. A dripping tub faucet is usually a cartridge or seat, scaled by Houston's hard water. Water on the floor after a bath points to the overflow gasket or the drain seal. Each has its own fix.
A leak under a tub is the one to act on fast, because it soaks the subfloor and the ceiling below without showing. In older homes, the faucet is often set in tile that cannot be matched, so we repair through the trim where possible and explain honestly when access has to open.
Slow drain, dripping faucet, wet floor: three problems, three fixes. Find which one you have.
Every job follows the same sequence so you know what is happening and when. We inspect, diagnose, quote, repair, and test, and you get a walkthrough before we pack up the truck.

Listens for the sound of water escaping behind the wall or under the floor so we can locate a tub leak without opening drywall first.

Confirms whether a slow tub drain is a trap clog or a main-line problem, and shows root intrusion in sewer line before we quote the repair.

Clears the trap and branch line on a slow tub drain. We use the auger first and move to the camera if the clog does not clear.

Clears grease, scale, and roots from the main line when a tub backs up with water from other fixtures. It restores full flow instead of just poking a hole.

Removes and replaces drain shoes, overflow fittings, and supply lines. The tube cutter gives a clean square cut for a press fitting or solder joint.

Makes a fast, reliable joint on copper or PEX tubing when a supply line behind the tub has to be replaced. No open flame in a tight wall cavity.

We fill the tub and let it sit, then run the shower and watch the drain, overflow, and surround seal. The wall does not go back until the assembly holds with no weeping at any joint.

Drain shoes, overflow gaskets, and wax rings are replaced to 2021 Uniform Plumbing Code (UPC) with Houston Amendments standards. That means the right gasket, the right torque, and a proper seal at the tub shoe.
We treat it as an active leak and confirm the source before opening anything. Call (346) 776-8560 during our hours — Monday through Sunday, 7:00 AM to 10:00 PM — and we will talk through the next step. The drain shoe and overflow gasket are the usual suspects, and we carry both on the truck. The leak stops, the ceiling dries out, and you know exactly which part failed so it can be watched in the future.
We clean and patch the crack with a two-part acrylic filler and reset the drain if the seal is compromised. If the crack has reached the structural layer, we quote a replacement instead of a patch. The surface is smooth and watertight again, and the tub holds water without seeping behind the surface.
We run a plumber's auger through the trap and camera the branch line if the clog is not in the trap. A main-line clog gets cleared with a hydro jetting machine before we close up. The tub drains in under a minute, and the shower stops backing up.
We assess whether the chip is surface-level or has reached the iron. Surface chips can be sealed; a rusted-through spot usually needs a refinishing specialist, and we tell you which one you have. You get an honest answer and a repair plan that matches the tub, not a patch that fails in a month.
Slow tubs from hair and soap scum are a city-wide call, with older tiled tubs in the Heights, Montrose and River Oaks needing trim-side faucet repairs, and slab homes in Sharpstown and Meyerland where a drain leak hides against concrete.
A tub in a Galleria/Uptown townhome was leaking into the ceiling below every time it was used. The stain had grown to about 18 inches across, and the drywall was soft to the touch.
We replaced the overflow gasket and drain shoe, pressure-tested the assembly, and confirmed the leak had stopped. The ceiling dried out over the next week, and the stain stopped spreading.
Check the overflow plate for looseness every few months and reseal the trim if it moves. A gasket that stays dry lasts longer.
A fiberglass tub in a Meyerland home had a 4-inch crack near the drain that caught on a sponge and had started to darken. The homeowner expected a full replacement.
We cleaned and patched the crack with a two-part acrylic filler, reset the drain, and sealed the edges. The tub held water for a full test and the surface was smooth again.
Avoid standing on the tub edge and use a non-abrasive cleaner. A patch that stays clean lasts longer than one that collects soap scum.
A tub in a Heights bungalow drained slowly for weeks and then started backing up with soapy water after a shower. The trap had been augered once before without a lasting fix.
We ran a camera and found scale and root intrusion in the branch line. We cleared it with a hydro jetting machine and confirmed full flow with the camera before we left.
Run hot water through the drain after each use and schedule a camera check every couple of years on older cast iron lines.
Most tub calls fall into a handful of categories: a leak at the drain or overflow, a crack in the surface, a slow drain, or water showing up below the tub. Each one has a different fix, and the diagnosis decides which one you need.

We trace the leak with a leak detection microphone, confirm whether it is the drain shoe, overflow gasket, or a supply line, and repair the failed part. Then we pressure-test the assembly so the ceiling stays dry. A tub leak that reaches the drywall can rot the subfloor and the ceiling framing within a few weeks. The longer it runs, the more of the ceiling has to be cut out and replaced.

We clean the crack, apply a two-part acrylic patch, and seal the edges. If the crack has reached the structural layer, we quote a bathtub installation instead of a patch that will not hold. A surface crack lets water into the tub's structural layer, and a small crack can spread into a full replacement if it is ignored. It also catches dirt and becomes a cleaning problem.

We run a plumber's auger through the trap and, when needed, a sewer camera to check the branch line. If the clog is in the main, we clear it with a hydro jetting machine before we touch the tub drain. A slow tub drain is often the first sign of a clog in the trap or the branch line. If it is ignored, the clog can move into the main line and back up other fixtures.

We replace the overflow gasket and reseal the trim plate, then test the overflow with a full tub. If the plate is corroded through, we replace it with a matching finish. A corroded overflow gasket lets water escape behind the tub wall every time the tub is filled. The damage shows up as soft drywall or a stain on the ceiling below, not at the tub itself.
A tub leak that drips for a month can rot the subfloor and stain the ceiling below. We trace the source, replace the failed gasket or drain shoe, and pressure-test the joint so the leak stops at the source instead of spreading into the framing.
Cast iron and original acrylic tubs are worth saving. Our bathtub repair services Houston focus on the failed component, not the whole fixture, so you keep the tub that fits the room and avoid a tile tear-out that can run three to five times the cost of a repair.
Most tub repairs finish in two to four hours. We carry common drain shoes, overflow gaskets, and wax rings on the truck, so a bathtub repair Houston appointment often ends with the tub back in service when we leave.
You get a price before any work begins, and it does not change because we found a second gasket. bathtub repair Houston Texas does not mean cutting corners; it means quoting the real scope and doing it once.
Clear records you can keep and share.
What failed and what we will replace
Quoted before the work starts
Tub filled and checked before close-up
Not every tub problem needs a new tub. The decision comes down to whether the failure is at a part or in the tub body itself.
A leak at the drain shoe or overflow gasket is a part replacement. The tub stays, and the repair is usually done in one visit.
A crack in the acrylic or fiberglass layer can be patched if it has not reached the structural layer. A crack that goes deeper is a replacement.
A chipped enamel spot on cast iron can sometimes be sealed. A rusted-through spot usually needs a refinishing specialist, not a patch.

Outside these areas? Call and ask if we can reach you. (346) 776-8560
Hair and soap scum build up in the trap and drain shoe. We clear the trap and branch line, then check the vent so the tub drains evenly. A hair catcher and a hot-water flush keep it clear between visits.
The cartridge or seat inside the faucet has worn or scaled up. Houston's hard water speeds that wear. A new cartridge or seat stops the drip.
Usually the overflow gasket or the drain seal. Water that escapes the tub soaks the subfloor, so this is worth fixing promptly. We test the overflow and the drain seal before we leave.
Yes. Estimates are free, and you approve the written scope before work starts. We are open Monday to Sunday, 7:00 AM to 10:00 PM.
Call (346) 776-8560 for a free estimate. We find the failed drain, faucet or seal, fix it, and test the tub before we leave, Monday to Sunday, 7:00 AM to 10:00 PM.
Call us at (346) 776-8560 to book bathtub repair or ask a question. We are open Monday to Sunday, 7:00 AM to 10:00 PM, and estimates are free.
The fastest way to book is a phone call. Tell us what is happening and we will give you a free estimate and a time that works, Monday to Sunday, 7:00 AM to 10:00 PM.
Open Mon–Sun, 7:00 AM–10:00 PM. Free estimates.